Grips and bar tape
More power? Check. Better traction? Definitely. Less shifting? Yup. Funky uneven pedal stroke? Not with Wolf Tooth’s PowerTrac Elliptical™ (PTE) chainrings. Our proprietary design means a slightly less ovalized ring (10%) with less aggressive...
This Premium narrow wide round chainring is designed for Shimano and other 104 & 64 bcd cranks. Super light and durable. It is the most Premium chainring on the market
The combination of secure grip and comfort was the focus of development of the 710. The preferred area of use is a comfort-oriented mountain bike or a sporty trekking bike. Due to the perfect fit, the bicycle grips cut a good figure in both areas.
Sram Chainring for 1x12 or 1x11 speed drivetrain. X-sync single retaining ring narrow wide tooth pattern. 40 tooth for 107 bcd spiders or power meters.
AXS enabled for easy monitoring and firmware upgradesBluetooth Low Energy and ANT+ compatiblePower readings are accurate within +/-1.5% and aren't affected by climate conditions during a rideUses a common CR2032 battery that last for 200 riding hours and
Threaded BB for BB86, BB92 and PF90 frames and 24mm diameter spindle cranks. Machined cups thread together for stability, increased bearing life, and simple installation and maintenance.
The direct mount chainrings for SRAM cranksets replace your existing spider and chainring with one clean looking, lightweight, and stiff piece of machined billet.
MegaExo bottom bracket for NBD MTB MegaExo cranksets. Ceramic bearings for minimum friction and maximum durability.
Thread together bottom bracket for frames using the PF30 bottom bracket standard. Two machined aluminum cups thread together keeping the bottom bracket stable in the frame, increasing bearing life, and simplifying maintenance.
Run 29mm spindle SRAM DUB compatible cranks in a BSA threaded frame. Machined aluminum cups thread in to a standard threaded frame and feature Enduro 6806/29 ABEC-3 sealed bearings outboard of the BB shell. Fully serviceable.
The PF30-SHIM adapts 24mm Spindle Cranks (Shimano, FSA, etc.) to work on Pressfit 30 frames. Simply tap the adapters into the 6806 bearing in the BB shell, install the spindle and cranks.
