Wheels Manufacturing

T47 threaded BB cups for T47 frames and 24.00mm spindle diameter cranks. Cups have internal bearings, and are typically used in BB shells with widths wider than 73mm. Machined aluminum cups thread together directly into a T47 BB shell.

The PF30-SRAM adapts cranks with 22/24 mm spindles (SRAM/Truvativ) to work on Pressfit 30 frames. Simply tap the adapters into the 6806 bearing in the BB shell, install the spindle and cranks. Use our Crank Spindle Spacers to adjust your chainline,..

Convert your PF30 frame to a single-speed setup with our simple to use eccentric bottom bracket. Enduro Angular Contact sealed bearings. Double lip seals on all bearings with high fill rate top quality grease for maximum durability.

The BB30-SHIM adapts 24mm Spindle Cranks (Shimano, FSA, etc.) to work on BB30 frames. Simply tap the adapters into the 6806 bearing in the BB shell, install the spindle and cranks. Use our Crank Spindle Spacers to adjust your chainline,..

Enduro 24x37 Angular Contact sealed bearing for 24mm crank spindle applications. Direct OEM replacement for most BB86/92, Trek BB90/95 and with all Wheels Mfg PF30 Outboard and BB30 Outboard BBs

Our solution for running a 30mm spindle crankset in a BSA threaded frame. Machined aluminum cups thread in to a standard threaded frame and feature Enduro 6806 Angular Contact sealed bearings outboard of the BB shell. Fully serviceable.

Thread together bottom bracket for frames using the PF30 bottom bracket standard. Two machined aluminum cups thread together keeping the bottom bracket stable in the frame, increasing bearing life, and simplifying maintenance. 

Enduro 22x37x8 2RS, ABEC-3 sealed bearing for GXP non-drive side bottom bracket cups. Inner race extends from bearing and matches the stepped down end of the GXP crank spindle. Install with inner race extension inwards towards the center of the frame.

Expand your choice of cranks for use in BB86/BB92/PF90/BB107 frames. Replace your bottom bracket with these dual-row flanged bearings and run 30mm spindle cranks in your frame. These bearings fit directly in frames with 41mm ID bottom bracket shells.

The PF30-SHIM adapts 24mm Spindle Cranks (Shimano, FSA, etc.) to work on Pressfit 30 frames. Simply tap the adapters into the 6806 bearing in the BB shell, install the spindle and cranks.

The BBUNIV-SHIM kit adapts Shimano or similar 24mm cranks to virtually any BB30/PF30 frame, including mountain bikes, 2x10 systems, narrow-shell road bikes, road triples, etc. For use only with bottom bracket shell widths from 68mm to 83mm.

The BBUNIV-SRAM kit adapts SRAM/Truvativ cranks to virtually any BB/PF30 frame, including mountain bikes, 2x10 systems, narrow-shell road bikes, road triples, Cannondale BB30a & PF30a, etc. Simply tap the adapters into the 6806 bearing...